How to Make a Water Elevator in Minecraft?


How to Make a Water Elevator in Minecraft: Transportation is essential when it comes to Minecraft. When you think about it, there are two sorts of transportation.

The first is horizontal with a horse or mine cart system, but the second is vertical transport with a lift.

There are many different ways to build a lift out of red stone, but there is only one right way to get out of the water. This lesson will walk you through the process.

Minecraft Water Elevator Equipment

  • glass
  • Water bottle
  • door
  • clip
  • Soul Sand (for climbing)
  • magma block (for landing)

How to make a water Elevator in Minecraft

To lift the water, you must have two columns of blocks so that there is a closed space between them. After making sure it is closed, install some gates to stop the flow of water, fill the column with water, then divert all the running water to the source block, and finally put your cap under the sand. Keep with the spirit to make bubbles. Move the magma block up and down to make bubbles.

Step-by-Step Guide

Here is a step-by-step guide to making a water Elevator in Minecraft.

Step 1) Before building a water lift, the first thing you want to do is assemble your glass. It doesn’t matter how many glasses you have, but the recommended amount is to figure out how high your lift is. Multiply this height by four. For example, if you want the elevator to go seven blocks, get 28 blocks of glass.

If you need help getting Glass, you can use this link.

Step 2) Now that you have a glass, you want to have a bucket of water. Just make a bucket and collect water in it.

If you need help making a bucket, click here.

Step 3) When you are in the water, take a dip in it. This is where you will find the rock if the body of water is the sea.

Step 4) Finally, go down. This is where you’ll find the spirit sand and magma blocks you need. These two blocks will explode in the space below, so just go and find out.

Step 5) Now that you have gathered all the items the first thing you want to do is build your own glass wall when building the water lift. This requires a blank block between the four columns you need. It can be as high as you want, depending on how far you want your lift to travel. Make sure you leave two block-long holes on one side of the column. This is where you will enter your elevator.

Step 6) Now, go to your elevator. With your back to the elevator, hold your door open. This will prevent water leakage from the lift.

Step 7) Now what you want to do is to fill the elevator with the block above the water bucket. This will allow water to pass between your lift glass blocks. The problem with this method is that each block of water must be a source block. Here’s how to set it up with a clip.

Step 8) Fill your water jug. Having a clip will create a source block for every flow of water.

Step 9) Now all you have to do is replace the block under the lift with soul sand or magma block. Replacing the lower block with civilian sand will lift the lift.

Replacing the lower block with a magma block will bring you down.


Please enter your comment!
Please enter your name here